When itry to boot up my SV07 it boots up most of the way and then starts at the begining again and gets cought in a loop

[JamesCRocks]

I had this problem a while back and, if I recall correctly, reflashing the BIOS:

SOVOL SV07 Plus: Major Print Issues Resolved But

So… I’ve been having a few issues printing and tried quite a few things with no real benefit. Initially, I was printing an MIB Neuralyzer (for a fancy-dress party in a month or so) which appeared to layer shift, then go completely mad. I made some errors, including switching the printer off and back on too quickly leaving the printer in a reboot cycle. Looking for a solution on the internet, I came across a post here which appeared to help, a reply someone had from SOVOL support which linked t…

I also had another issue where I resolved it by deleting one of the cfg files… I was able to reach it by going to its IP address and then the “Machine” section.

James