When I received my SV08MAX, the wifi did not detect any networks at all, after a lengthy troubleshooting exercise Sovol sent me a new main board. This new main board did detect the wifi and I was finally able to connect…until about 30 seconds went by and it resets the IP address. It does this over a…

If you have an STLINK adapter, EMMC flash adapter and are willing to take on the configuration burden, the board will run full open source instead of the OS/Klipper fork that SOVOL distributes. I have my mainboard running on Armbian:Trixie (flash the EMMC with this) and then you will need to flash …

[image] akara1: I have wasted so much time trying to get this printer to work properly. Now its out of warranty because sovol dragged their feet, and they took the main board off their website so I cant even buy it. what a joke. 1st: just because Sovol removed the board doesn’t mean they stil…

I have been emailing them!? Your post is not helpful and neither is Sovol support. Thats why I am reaching out to the community here, sovol products seems to depend on community support just to get basic functionality working. I am still looking for a solution to the wifi reset loops and also the we…

Thanks for the info TimberSD, I do have an EMMC adapter so I may try this as a last resort.

Alternate solution: [image] Amazon.com: TP-Link AC1200 WiFi Extender, 2023 Engadget Best Budget Pick,... Stronger, More Stable Wi-Fi, Where You Need ItUpgrade your home network with the TP-Link Wi-Fi Range Extender RE315. The AC1200 extender connects to your existing router and expands i…

@akara1 With a new main board, you hardware address (MAC) will be different. Check in your WiFi router that the old MAC address is not still being used for the IP the printer is using. If you manually enter the IP on the printer during setup and now have a different mac, this reconnect, disconnec…

Sorry for the inconveience caused. We will reply the email ASAP. If you don’t buy the accessory in our webiste, you can send the email to info@sovol3d.com . Our after-sales staff will provide the purchase link to you

@cardoc thanks for the link to that extender, I was thinking about this as a solution. It does work fine on ethernet but I am unable to run ethernet to my installation so the extender might work as a solution. @MikeHides this issue persists even across different routers, Ive also connected it to m…

Hello, You may have assigned an IP address to the motherboard based on its MAC address. In that case, the old IP address will no longer work.

Sv08 max two bad main boards in a row!

Sovol SV08 MAX

Lion March 25, 2026, 11:17am 16

At the end of that thread, you didn’t post that someone had a fix.

Topic		Replies	Views
SOVOL SV08 buy a brick Sovol SV08	14	895	October 4, 2024
Where is the firmware when your printer does not boot up and start sequence specially when it’s fresh out of the box and not completed it start up sequence help where is the firmware please Sovol SV08 MAX	6	160	December 31, 2025
First boot Klipper error Sovol SV08 MAX	69	491	October 31, 2025
SV08 Max layer shift on test benchy Sovol SV08 MAX	14	455	February 25, 2026
Major issue Sovol SV08	15	747	November 18, 2024

Sv08 max two bad main boards in a row!

Related topics