[20230121_212521520] I finished leveling my bed, and an error popped up for Bed Temp, and to reset. I checked under the bed and this wire was disconnected. What can I do?

Honestly? The fast way is to strip a bit of the insulation & solder it or ask someone who is capable of doing that for you. The other way: Make a warranty claim, send your printer abroad & wait until it comes back…

They will send a new bed out and you can replace it quite easily, no need to send the printer back. [image] Sv06 failure Sovol SV06 Fully Open Source 3D Printer I had a similar problem but mine was the positive lead coming off. As the bed bled the heat from my soldering …

SV06 Wire attached to bed disconnected?

Sovol SV06 Fully Open Source 3D Printer

sovol3delger April 12, 2023, 4:51pm 3

They will send a new bed out and you can replace it quite easily, no need to send the printer back.

Topic		Replies	Views
SV06 Thermal Runaway Sovol SV06 Fully Open Source 3D Printer	6	664	April 8, 2023
SV 06 heat bed causes error Sovol SV06 Fully Open Source 3D Printer	21	3473	May 10, 2023
Bed temperature error Sovol SV06 Fully Open Source 3D Printer	13	2261	August 1, 2024
Bed heating failure Sovol SV06 Fully Open Source 3D Printer heat-fails	3	466	April 8, 2023
SV06 - Bed Heating Error Sovol SV06 Fully Open Source 3D Printer heat-fails	14	3245	August 1, 2024

SV06 Wire attached to bed disconnected?

Related topics