SV06 - First Time Printing PTEG - Here’s my calibration cube. Recommendations? KLIPPER

[KLB331]

I used the stock “generic PTEG” settings from Orca Slicer on a Klipperized Sv06 and I think it came out pretty darn good but I know there’s some stuff I can tweak but I’m not sure what they would be.

Suggestions?

(I can only post one photo so I had to pick one out of several)

[KLB331]

Here is another side

[KLB331]

Z

[Lion]

I’ve been saying this a lot this past week…I don’t know anything about Klipper…but I know ringing/ghosting when I see it.

https://www.klipper3d.org/Resonance_Compensation.html

[KLB331]

I appreciate you responding even if you don’t know klipper!!

Thanks.