WIP: Sovol SV08 - Optimized G-Code / Macro.cfg / printer.cfg and highspeed settings PETG

After 10 hours of printing PETG with my Sovol SV08 and 0.6mm nozzle i made optimizations to Klipper and to the Orca slicer.

See this thread, this printer should be shipped with these fixes in firmware, to make printing easy.

Reddit r/Sovol Optimized Settings

Please comment to make it even better. Sovol SV08 hardware is amazing, so should be it’s settings.

1 Like

Yea I contact Solvo twice now enquiring as to is or will the SV08 shippey with updated printer firmware, to improve its usability. I soid that as it stands if I pre prehat the bed for asa / ppg or sothe printer wont start a print until the bed temperature drops to 65 digress? This is crazy, you havent hot a way to heatsoke the bed to allow the bed to stabilise to the temperature you needed to print the particular filiment you are going to print with,that is nonsense and a time waster. They disgraced my suggestions and said to heat the bed to 65c As thate what their policy is? Topal Bull.

1 Like

New version for optimized Macro.cfg and printer.cfg out for firmware 2.4.6