My SV06 is a few months old and now it will not heat the bed, it shows “???” were the current bed temp should be.

Hi @salsa Sorry to read about the matter. Hope the suggestions from engineer might help you resolve the issue. Unplug the thermistor from the heated bed and see what temperature is displayed. Swap the thermistors between the nozzle and the heated bed and see what is displayed. [image] If the va…

Hi @sovol3d , I have a similar issue. This is what the temperature display shows: [image] I swapped the nozzle and bed thermistor wires and the “err” is shown under nozzle temp instead.

Hi i have the same issue… what did you do?

I have the same error… what should i do now?

I have the same issue after two months of use. Send an email to Sovol Team to fix the problem.

Has anyone been able to resolve this issue. I have a new printer that is less than a week old this happened to.

First, try what @wahhaj did. If your result is the same, then the thermistor is gone. Not funny with a new machine, but not worth flying to China and grab some Sovol techies (which sometimes looks like the only way to get any reaction from them). Thermistors are easily replaced, and they are dirt c…

I have been plagued by this problem before. Sovol very kindly sorted it out for me by sending out a new Bed. However, when it happened again, they completely ignored me even though I only wanted some advice. I managed to fix the issue by purchasing a new Thermistor and wiring back to the control boa…

I just got the same error display under the print bed on the screen. Had the Sovol 06 since December 22 2023, not even a whole month. What can I do to fix this, or do I need to replace wiring or the hot bed itself?

same issue here, swapped the cable and err message swaps from bed to hot end. my printer is a month old, can anyone please tell me what to do?

SV06 - Bed Heating Error

Sovol SV06 Fully Open Source 3D Printer

jedallen August 1, 2024, 3:44am 14

I had the same issue, see SOLVED: Err: MINTEMP E1 Bed

Topic		Replies	Views
Bed temperature error Sovol SV06 Fully Open Source 3D Printer	13	2287	August 1, 2024
Sovol V06 Err (Bed Temp) Sovol SV06 Fully Open Source 3D Printer	6	118	January 9, 2025
Weird temperature problem Sovol SV06 Fully Open Source 3D Printer	4	94	May 12, 2025
Sovol sv06 error mintemp bed Sovol SV06 Fully Open Source 3D Printer firmware , heat-fails	7	1208	March 24, 2024
SV06 Heating failed Sovol SV06 Fully Open Source 3D Printer	1	446	November 14, 2023

SV06 - Bed Heating Error

Related topics