Sovol sv06 after firmware upgrade Z axis crashed into bed

Sovol SV06 Plus
1

Hi after a firmware update to SV06V2.0.0A_2.24-BCI tried to Auto Z-align. When finished moving to the center, Z start coming down and crashed into the bed leaving a dent and bending the X axis rails.
Is there a way to Home Z axis without the move down before going to the top?

Thanks
Jim
Display show V2.0.0._A

2

Surprising.
Before doing a auto-home starts by doiing a z-align.
Normally, the axe will go to the top before going down to the plate.