Quad Gantry Leveling

Sovol SV08
1

I’m confused about my Quad Gantry Leveling. It probes each of the 4 corners. The thing is, it is about 2" inside on the left side, and only about 1/4" inside on the right side. I would expect it to probe each corner equidistant from each edge both front/back and side. Is the offset probe points expected?

BTW, this is a brand new SV08, just put it together and am going through ellis’ Print Tuning Guide. No changes to any klipper cfg files yet.

-gregma

2

no changes should be necessary.
I use the stock settings (with the tuning via Orcaslicer and the menu from the printer itself) without any changes without issues on even very small prints in PET-G and TPU.

1 Like