So almost every other print I do fails due to bed adhesion if the print is longer than an hour. I’ve tried brims, rafts, dropping the Z-offset to smash filament in, increasing first layer flow, 65C bed with PLA, 100C bed with ABS, 0 gap extra large brims, and of course cleaning the bed and glue sti…

I think that photo presenting such failure would help with identifying.

Happy to provide one, but of what? A detached string mess is what I get. As for first layer, the usual bumby, properly filled (except when I over extruded on purpose) bottom layer.

Check your extruder temperatures. A number of us have found the thermocouple on the Max is reading high and the extruder is actually 15° or 20° cooler than reported by Klipper. I made extensive measurements, reported the issue both here and to Sovol direct but after an initial e-mail requesting more…

Thanks! I will take a look. I found a post about Bamboo printers and tall parts, and have switched my infill style and slow the print down halfway up, and so far, two successful prints. It’s possible the print head isn’t moving up enough to not scrape the part as it gets taller and the center of gr…

Doh, I read it in my email vs on here, and it didn’t show the link. Thank you.

Poor bed adhesion, anyone else?

Sovol SV08 MAX

torch November 19, 2025, 2:17am 6

I guess you missed the link in my post above. I outlined it, with IR photos and contact measurements in this thread: Extruder temperatures

Topic		Replies	Views
Extruder Hits Print on my Sv06 Sovol SV06 Fully Open Source 3D Printer	3	334	February 21, 2024
Adhesion issue on the print bed Sovol SV06 Fully Open Source 3D Printer	2	214	July 2, 2024
Failure adhering in the same corner Sovol SV04 IDEX	5	294	December 7, 2022
No longer sticking to bed Sovol SV06 Plus	18	1272	April 8, 2024
Help on print not sticking Need Help	22	1428	May 19, 2022

Poor bed adhesion, anyone else?

Related topics