Tonight I started a print like I would normally do from orcaslicer. After about an hour I went to check the camera from my phone and had the shock of my life: there was terror in every image. The print head was dragging around blobs of molten plastic together with the detached extruder case along t…

Mayor crash after many flawless prints

wrusman September 11, 2024, 9:50am 8

Modified all 3 nozzles with roll pins yesterday.

1 Like

New SV08 today, Is it safe to print PETG?

Topic		Replies	Views
Sovol SV08 crashes into bed and "dances" Sovol SV08	4	353	October 6, 2024
New SV08 today, Is it safe to print PETG? Sovol SV08 filament	12	737	October 18, 2024
Filament wrapping around the nozzle Sovol SV08 advice , filament	13	289	December 31, 2024
Sovol Sv06 no print finished Sovol SV06 Fully Open Source 3D Printer heat-creep	57	3460	December 9, 2024
Sovol SVO6 fails printing around the same layer each time Sovol SV06 Fully Open Source 3D Printer	43	3984	April 17, 2024