I am getting a “!! Move out of range: 247.673 142.389 0.240 [59.341]” message when trying to print a certain file. X = 192mm Y = 192mm Z = 2mm I have done a “Reset to Factory” and then a full calibration but I still get the error.

Getting Error Message

Lion January 18, 2025, 7:11pm 5

I just saw that in your screenshot…yes it makes a difference as the Plus is bigger.

Read this:

1 Like

Topic		Replies	Views
Good printer Sovol SV06 Plus ACE	5	481	March 22, 2025
Slice looks good, prints off center Sovol SV04 IDEX	4	795	July 18, 2022
Homeing problems Sovol SV06 Fully Open Source 3D Printer advice	0	341	April 13, 2023
Unable to print anything with a new SV06 ACE Sovol SV06 ACE	42	239	July 23, 2025
Hoping for some info on settings Sovol SV06 Plus	2	537	May 23, 2023