Hi all, I was having issues with my SV08 and thought if i did a simple factory reset and fresh install of Orca would it would reset the printer back to the way it came when i got it on release… Oops! that was a mistake. All this in an attempt to be able to print some ABS that wasn’t sticking to the…

See this thread: [image] Sovol sv08 firmware V2.4.7 Firmware I updated to the new firmware V2.4.7 and now my 5 inch HDMI Display is up side down I’m new at Klipper all my other printers are Duet3D controlled have no clue how to fix it. I seen other post says …

Factory Update through Mainsail and now HDMI screen upside down

Sovol SV08

cardoc August 8, 2025, 2:30pm 2

See this thread:

Topic		Replies	Views
Sovol sv08 firmware V2.4.7 Firmware	20	1186	August 23, 2025
Major issue Sovol SV08	15	755	November 18, 2024
Tried putting my sv08 on mainline klipper and now I'm stuck on booting screen Sovol SV08 firmware , advice , klipper	9	2032	December 26, 2024
SV08, endless scrap? Sovol's support fails Sovol SV08	24	1175	May 4, 2025
Bricked my printer - can't recover Sovol Klipperized SV07 firmware , klipper	7	139	November 17, 2025

Factory Update through Mainsail and now HDMI screen upside down

Related topics