Hi everyone, I’m looking for some technical information about the Sovol SV08 mainboard, specifically the 24 V Exhaust Fan output controlled by MCU pin PA2 (fan3 in the stock Klipper configuration). Does anyone know the maximum continuous current rating of this fan output, or perhaps the part number of the MOSFET/driver used for PA2? The reason I’m asking is that I’m designing an external recirculating filtration system for my enclosed SV08. The idea is to reuse the original rear exhaust fan and add two 24 V 5015 blowers for an activated-carbon + HEPA filtration system. The original exhaust fan in my printer is: HXR EFC-09E24L – DC 24 V – 0.15 A The two additional 5015 blowers are approximately: 2 × 0.08 A = 0.16 A Therefore, in the worst case, if both systems were operated simultaneously, the PA2 fan output would see approximately: 0.15 A + 0.16 A = 0.31 A @ 24 V I’m considering using relays to select between: original exhaust fan only filtration blowers only possibly both simultaneously Before doing that, however, I’d like to know the actual safe current capability of the PA2-controlled 24 V fan output, rather than simply assuming that 310 mA is safe. If anyone has a schematic, high-resolution photo of the SV08 mainboard, MOSFET part number, or an official current specification for this output, that would be very helpful. Thanks!

There is a pic in this thread, don’t know if it will suit your needs or not. [image] SV08 64bit controller pin-out Sovol SV08 [MCU-PinMap] I found the pin mapping with an OHM meter, GND and Vcc were measured to the main voltage terminals to the pins in question. Z,X,Y stops, Filament Detection and FAN/LED connectors NOTE: I just ordered a Bambu Labs printer, I’m spending more time working on: Creative K1 (dead end, no fix), Twotrees SK1 (New Main board, heat bed, Z axes tri-supports) and this Sovol SV08 (wiring issues, heated chamber with add-on MCU, upgraded Klipper with EMMC 32GB, case encloser with extensions, po…

The MCU schematic shows PA2 is pin 25. You’ll have to do continuity tracing in your board. H616_JC_6Z_V1_2_MCU.pdf OR just spend a dollar and remote mount a mofset and drive it with the 24v PWM output from the fan connector.

Tks a lot. I take a look inside PDF and I hope could be useful. About this “OR just spend a dollar and remote mount a mofset and drive it with the 24v PWM output from the fan connector.” I’ve already planning a little PCB to split voltage from 24V PWM for Fan and a double filtering system

Exhaust Fan output

Sovol SV08

Lion September 18, 2026, 5:49pm 2

There is a pic in this thread, don’t know if it will suit your needs or not.

Topic		Replies	Views
Fan pins not defined in MCU PDF Sovol SV08 MAX	22	1443	May 11, 2026
SV08 64bit controller pin-out Sovol SV08	10	8218	September 16, 2025
Enclosure fan Sovol SV08	6	2613	August 26, 2024
SV08 Enclosure case fan - how to make it spin? Sovol SV08	6	2409	March 17, 2026
Extruder Auto-Cooling Fans Sovol SV06 Sovol SV06 Fully Open Source 3D Printer extruder-kit	9	2725	August 16, 2023

Exhaust Fan output

Related topics