Hello friends!! Please I need you help🙏 Yesterday when trying to preheat the hotend I noticed that the screen read 9 degrees (the room temperature should be 22 degrees at the moment). Those 9 degrees were still on the screen but I could see that the hotend was heating up since the plastic was melti…

Swap the hotend & the bed plugs to see if the problem follows. If so, contact Sovol: info@sovol3d.com

Hello Lion, and thank you! I already did it and the funny thing is that the 9 degrees continue to appear on the hotend, not on the bed even if I change the connectors…totally lost

You swapped them on the breakout board right…not the main board…??

[IMG_20230709_171955] Main board…

This thread might help. [image] SV06 - Bed Heating Error Sovol SV06 Fully Open Source 3D Printer My SV06 is a few months old and now it will not heat the bed, it shows “???” were the current bed temp should be.

Thanks again Lion, initially when I exchanged the thermistor connections the error occurred if it went from the bed to the hotend. Now I get an “err” in the bed and the hotend stays at 9° (even with the thermistor cable unplugged from the board). Both the bed and the hotend get them to heat up bec…

You haven’t said how long you’ve had this printer. Just in case it’s new & you’ve never used it…check the voltage is set to your country. It sound like the thermistor. You should contact Sovol at the email I posted above. It usually takes them about 2 weeks to answer. If you don’t want to wait, …

Lees than 2 months of use. I will contact with them Thank a lot friend!

SV06 hotend temp stuck at 9° on LCD

Sovol SV06 Fully Open Source 3D Printer

Lion July 9, 2023, 5:08pm 6

This thread might help.

Topic		Replies	Views
Weird temperature problem Sovol SV06 Fully Open Source 3D Printer	4	125	May 12, 2025
SV06 - Bed Heating Error Sovol SV06 Fully Open Source 3D Printer heat-fails	14	3392	August 1, 2024
Bed thermistor problem Sovol SV06 Fully Open Source 3D Printer	2	348	April 8, 2023
Bed temperature error Sovol SV06 Fully Open Source 3D Printer	13	2343	August 1, 2024
Temeratur steigt kontinuierlich an obwohl mittlerer weile nichts mehr am Board angeschlossen ist Sovol SV06 Fully Open Source 3D Printer	3	111	April 22, 2024

SV06 hotend temp stuck at 9° on LCD

Related topics