So my bed died on friday tried to repair it. it heats up but the pla won’t stick after the second layer. Gues i just need a new bed. [afbeelding] [afbeelding]

If it heat up your bed isn’t dead. It’s working as intended. Redo your bed leveling. Use glue stick. Use brim. Increase bed temperature.

Hello, I think this response is for someone else. I sent a request to check on a new purchase.

How do I unsubscribe to these emails?

Go to https://forum.sovol3d.com/ Click on your initial in the upper right corner Click on the bottom icon “Profile” Choose “Preferences” Click on “Emails” in the toolbar Set everything to “Never” and uncheck all boxes Make sure to click on “Save changes” at the bottom

Sounds to me like your Z offset is too far from the bed. Use the Probe Z Offset function to lower it until a piece of paper makes contact with the nozzle. Save Settings. And follow the other responders advice if you still have problems.

I did the z offset so the nozzle schrappes the paper hard, But doesn’t tear it so maybe its to close?

I had this problem when cleaning the bed with IPA, it became like teflon to my PLA+ though it worked with the sample that came with the printer. Take to to the sink and scrub it with dish soap… Also print the first layer with .3 layer height, 5 degrees warmer than normal, 115 % feed, and 30 mm per…

hm, the outer ring looks pretty good. have you tried another 3d-model? do you have any possibility to measure the true temperature of your print bed? Print beds can also be partly damaged, for example I have an PrusaMK3 Printbed with a corner that has 10°C lower temperature then the rest. since the…

What is the bed temperature for your print.

Need a new bed

Sovol SV06 Fully Open Source 3D Printer

3dprinter April 11, 2023, 5:14pm 2

Try cleaning it with some soap and warm water, and looks like your nozzle is a bit to close try calibrating it. What temperatures do you use?

Topic		Replies	Views
No longer sticking to bed Sovol SV06 Plus	18	1205	April 8, 2024
Bed leveling sovol sv06 plus Sovol SV06 Plus	6	1715	January 2, 2024
Nozzle crashed in to bed Sovol SV06 Fully Open Source 3D Printer	8	1784	January 22, 2026
SV06 - bunching up and not sticking to bed Sovol SV06 Fully Open Source 3D Printer advice	27	2519	April 24, 2024
Sovol SV 06 Not working at all with new filament Sovol SV06 Fully Open Source 3D Printer	18	47	January 18, 2026

Need a new bed

Related topics