My SV08 just arrived today. I plan on mainlining it, do I even need to start it up as is? Is there firmware needing to be updated w/ Sovol code? If I have a spare EMMC, can I just start off the new Klipper image, on the new EMMC?

I highly recommend starting it up before you start the mainline process. You will need to know your serial numbers from the MCU of the Main Board and the MCU from the toolhead board. you can get them one of 2 ways. Open your printer.cfg file and look for the lines as is pic. SSH into your printe…

Mainline New SV08: Do I even need to boot w/ original EMMC?

Sovol SV08

cardoc April 29, 2025, 11:36pm 4

https://forum.sovol3d.com/t/tried-putting-my-sv08-on-mainline-klipper-and-now-im-stuck-on-booting-screen/6083?u=cardoc

Topic		Replies	Views
Tried putting my sv08 on mainline klipper and now I'm stuck on booting screen Sovol SV08 firmware , advice , klipper	9	1073	December 26, 2024
Bricked my SV08 attempting to go to Mainline Klipper Sovol SV08 klipper	4	349	April 17, 2025
Sovol replacement motherboard Sovol SV08	3	64	May 22, 2025
Getting the Sovol SV08 onto mainline Klipper Sovol SV08 firmware	0	2011	September 2, 2024
Stuck "system booting" after updating firmware Sovol SV08 firmware , advice	6	374	November 29, 2024

Mainline New SV08: Do I even need to boot w/ original EMMC?

Related topics