Hi there,
I’m having an issue with the slicer (Sovol Cura 1.5.7) for my Sovol SV04 dual-mode printer. I want to print infill in a different color than the outer walls (so that it looks nice and visible on the inside). I set extruder #2 for infill and the other for walls. However, the printer first prints normally, just like in single-extruder mode, starting with the outer walls and then switching to the second extruder for infill, immediately printing another layer with that extruder, and ending with the walls. This causes an unsightly effect after printing. Is there a way for the printer to always print the outer walls first, and then the infill, and after finishing the layer, start with the outer walls again?
