I think my extrution is off?

[ulao]

I saw this reply

If someone could paste the output from M503, I would appreciate it

Send: M503 Recv: echo:; Linear Units: Recv: G21 ; (mm) Recv: echo:; Temperature Units: Recv: echo: M149 C ; Units in Celsius Recv: echo:; Filament settings (Disabled): Recv: echo: M200 S0 D1.75 Recv: echo:; Steps per unit: Recv: echo: M92 X80.00 Y80.00 Z800.00 E691.50 Recv: echo:; Max feedrates (units/s): Recv: echo: M203 X500.00 Y500.00 Z10.00 E50.00 Recv: echo:; Max Acceleration (units/s2): Recv: echo: M201 X2000.00 Y2000.00 Z100.00 E5000.00 Recv: echo:; Acceleration (units/s2) (P<print…

and did a compare. All of my g29 codes are not the same, is that ok?

also my M203
is X500.00 Y500.00 Z10.00 E20000.00
not
X500.00 Y500.00 Z10.00 E50.00

and my M205 iB20000.00 S0.00 T0.00 X5.00 Y5.00 Z0.40 E4000.00
not
B20000.00 S0.00 T0.00 X5.00 Y5.00 Z0.40 E10.00

that is wrong right?