Printing pla+ now and using the nozzle temp and bed temp at 210 and 70. (Recommended anycubic pla + is 205-216)
Printing at 60mms speed and retraction was set to .5mm at 35mms
I had pretty bad stringing for a big print and last night a tall yet simple print failed with 50mms speed and 20 brim
Here’s the pic of stringing.
Basically I wanted to see what other settings people successfully use for PLA plus
Thank you
Thank you ! Would you mind sharing your other settings as well for PLA+?
Speed
Travel?
Cool thanks a lot! What do you use your printer for? I see you answering a lot of questions people have! If you don’t have a channel or something you should and if you do I’d like to follow!!
Thanks again!
I use it mostly for printing things I need or just think are cool.
I do a little designing & remixing. I also print some things I donate.
I want to design more, but it’s hard for me to read about how to do it than to have someone show me how to do it.
That’s what I do too! Minus the donating, I do gift a lot more 3D stuff now haha and modeling stuff seems hard, I tried using blender but mostly had success remixing stuff and using 3D builder!
Started 3D printing for Star Wars cosplay and that’s been a journey, got this sv06 plus for full buckets and it’s been good learning new stuff. I tried at printing stuff with the .6mm nozzle and got speed bumped and then again with pla+
You don’t know what you don’t know !
