Hey everyone I have the following problem with my new Sovol SV06. It printed fine for like 30 days but then it stopped to show the current temperature of the bed. In its place there is only err. If i try to start a print or preheat the bed it shows a error message: ‘ERR: MINTEMP: Bed PRINT HALTED …

I’m having the same exact issue and I have seen a few other posts saying the same thing. If I had to guess, they have a bad batch from their manufacturing process. I have reached out to Customer Support and suggest the same. Otherwise I will try to keep others informed of what happens with Customer …

@sovol3d , maybe this is something that you could give guidance on or can make a post about to help with basic troubleshooting and next steps?

Iv’e got the same problem. Contacted costumer support about it. After a quick soldering the bed heats up but now the prints won’t stick anymore. I’ll keep trying all the advise i get here until i get it to work again. Gues it’s a learning curve :rofl:

I have the same problem. I found that sometimes if I wiggle the cable at the back of the bed it fixes but it always happens again and today I tried to fix it with a wiggle and it still did not work.

Update to the Problem: I e-maild the support of sovol. They need the serial number of your printer. To speed things up have it ready, if some of you with a simular problem decide to file in a report too. (you find it on the underside of the powersupply) After that they wrote back they would sen…

Did you solve the problem? How?

Did you solve the problem? Howw?

Hi I have the same problem; did you find a solution? I have E-mailed Sovol but have had not reply.

Did you solve the problem? How?

If wiggling the cable results in working sometimes, not others, it is almost certainly a bad thermistor. The wires are thin, the thermistor itself is high resistance (about 100,000 ohms default), and so if the wires are not rock solid that 100,000 can start to look like 500,000 or more. It’s not my …

Bed temperature error

Sovol SV06 Fully Open Source 3D Printer

jedallen August 1, 2024, 3:43am 15

Some people having this issue. See: SOLVED: Err: MINTEMP E1 Bed

Topic		Replies	Views
SV06 - Bed Heating Error Sovol SV06 Fully Open Source 3D Printer heat-fails	14	3350	August 1, 2024
Sovol V06 Err (Bed Temp) Sovol SV06 Fully Open Source 3D Printer	6	132	January 9, 2025
Sovol sv06 error mintemp bed Sovol SV06 Fully Open Source 3D Printer firmware , heat-fails	7	1271	March 24, 2024
Weird temperature problem Sovol SV06 Fully Open Source 3D Printer	4	111	May 12, 2025
SOLVED: Err: MINTEMP E1 Bed Sovol SV06 Fully Open Source 3D Printer	0	683	July 30, 2024

Bed temperature error

Related topics