OK,
I was getting some niggling problems so, in an effort to do it properly, I uninstalled my OrcaSlicer and followed gerGO PRINT 3D’s video, “Guide to Using Sovol Klipper with Orca Slicer and Christian Vick’s Klipper Additions SV07/+ SV06/+” which went fine until the point I had to add filaments, here (from adding printers, adding filaments is maybe 15 seconds later):
NOTES:
- I’m using Orca v2.3.0 stable rather than v1.9 something as in the video.
- At this point the I only have the SOVOL SV07 printer installed (not my SV07+), the one GerGO says to install because CV Additions are based on that (it’s precisely what his video tells viewers to do).
- My sole departure from the video is that I only imported “CV 1.55 SV07 Plus.json” because I only have an SV07 Plus.
The message I get when I try to import the filaments is:
“There are 0 configs imported. (only non-system and compatible configs) Hint: Make sure you have added the corresponding printer before importing the configs.”
It doesn’t matter whether I select “Sovol SV07 0.4 nozzle” or “CV 1.55 SV07 Plus”, I get the same message.
Any ideas?
James