I ordered an SV08 on April 18, 2020 and then received it at the beginning of July 2024. From the beginning I had problems with the Z-Offset, which destroyed a printing plate and a nozzle, so I contacted the support. Support then replaced this for me. (25.7.2024). Z-Offset had to be adjusted +/- …

[WhatsApp Bild 2025-03-11 um 23.47.34_f83aed63]

I really don’t know what to do anymore. I haven’t been able to use the printer since 31.12.2024, over 45 emails have been sent back and forth, but my printer doesn’t work. How can I proceed and put pressure on them to help me? I don’t care how, refund the money or send a new printer, but I have t…

Not much help except this The Host referred to in the error is the machine running Linux and under that klipper. The SV08 mainboard includes BOTH a SBC (equivalent to a raspberry Pi) and a MCU “board”. The software treats them as separate devices even though they are on the same circuit board. A…

I understand you but what is this torture print? You tried to print with supports on 100% of bed capacity? Honestly that is probably not realist to hope to print it successfully without big improvements of the basic SV08 + fine tuning. So yes, you will have to spend more time to tune it (isolate th…

I understand that a large print will not be perfect without improvement. But when I buy a printer with a 350x350m print bed, I expect it to be able to print a 300x240mm part! But for the printer to stop at 50% and claim that it’s finished, that it shifts the layers by 2cm, that it simply switches o…

I’m still new to Klipper, so bear with me. If the print says it’s finished, wouldn’t this be a Klipper or Slicer problem..?? I do know from just a couple months of Klipper that on my prints Klipper/Obico say’s it’s finished 100%…that it usually has 45 to 90 min left till the print is actualy finis…

[image] Calmato67: But when I buy a printer with a 350x350m print bed, I expect it to be able to print a 300x240mm part! You have right to expect that… but no that will not works like that (we had all the same experience related to that). I had an Ender 3 (2018) before to get the SV08 so i am…

Try this Timer Too Close Klipper Error: 32GB EMMC upgrade and other possible fixes for Sovol SV08 #AliExpress According to this guy he had a bad eMMC

SV08, endless scrap? Sovol's support fails

Sovol SV08

wrusman April 22, 2025, 1:18pm 15

SV08 - overcoming high-temperature Klipper Shutdown problem - my solution

Topic		Replies	Views
Can't get (used) SV08 to print Sovol SV08	13	194	April 23, 2026
Need help, many errors keep popping up SV08 Max Sovol SV08 MAX	28	145	August 1, 2026
First boot Klipper error Sovol SV08 MAX	69	710	October 31, 2025
Sv06 failure Sovol SV06 Fully Open Source 3D Printer challenging , heat-fails	40	3440	August 19, 2023
Eddy and Beacon SV08 Sovol SV08	44	1952	November 1, 2025

SV08, endless scrap? Sovol's support fails

Related topics