SV06 mainboard

Sovol SV06 Fully Open Source 3D Printer
1

I just installed the Sovol SV06 silent mainboard into a Creality Ender-3, but it is ignoring the minimum endstops for the x and y axis, the z axis endstop works just fine. I have updated firmware from Sovol3d and Creality, also have compiled Marlin 2.0.8.6 in Visual Studio Code, reversing the endstop pin settings within the firmware, all to no avail. If anyone has a solution I would love to hear it, thanks for the add to your forum.

2

SovolSV06SilentMainboard_SovolSV06PlusSilentMainboard_1_2500x
SovolSV06SilentMainboard_SovolSV06PlusSilentMainboard_1_2500x745×516 96.1 KB

I have figured it out. I missed a very small toggle switch on the board, but when I noticed it in an image on the web, I took my cover back off and it was in the on position. All the images I have seen of the switch, it was in the off position. I switched it to off, works perfectly now.