Reliable procedure to swap/replace filament

[genaro]

Thanks a lot Bjorn for your works, It’s what allow me to no through away the printer the first day.

I will still research a way, some fellows on the facebook group, managed to use 4 or more colors in a print.

It seems pause it may be a board failure.

Pause at Layer Height Mutiny

Context: Sovol SV04 printer I am trying to embed a magnet in a 3d print, So logically, I use the “pause at print height” (pause at layer height specifically) I run the print, (this is the mutiny part) it pauses, I embed the magnets, then NOTHING. I don’t have an option to resume print. (after reading thru forums) I decide to turn of the printer, and as it restarts it resumes the print, yet it starts printing 5 mm above the print. Basically, its just extruding on thin air above the print (gu…