Lion
July 29, 2025, 1:13am
7
Screws are hard to print sometimes, could be the threads or the height.
darbysan:
When I checked on it at 85%, you could hear the bed slamming hard at the rear of the printer on full travel when it tried to print at the front of the part. Don’t know if this is a bed issue, or a file issue. I printed 3 different parts from this “assembly”, and all of them exhibited this same behavior at 38MM up from the bed.
This part has me a little confused…with the part orientation on the Y Axis.
Just got a new svo6 ace but I’m having trouble with the y axis. It seems to be travelling too far foreward and hitting the end of its travel. When it does this it makes a thud and a clicking sound.
I have tried all the calibration settings and updated the firmware from v15 to v19 but still no luck. While doing a test print (benchy) it gets halfway through then skips alignment about 4mm then skips back a little bit further on. Im guessing it’s all related.
How does it sense the end of its run? …