Thought it would be good to have a place here to talk about octoprint on our Sovol printers.

Just wanted to note that when I first started using Octoprint the Print Time Left estimages were way off, much longer than the actual. I added a plugin called the Ocotprint PrintTimeGenius plugin and on my first print with it today the time left estimates appear to be spot-on. Worth a look.

Info here on backpowering when using a Pi to run Octoprint. Backpowering can cause erratic behavior. [image] Octoprint causing sv06 to lose its mind occasionally Sovol SV06 Fully Open Source 3D Printer This sounds like it may be back powering from the printer…intermittent…

On some Sovol printers {SV05 confirmed) on current firmware you need to modify the HOST_ACTION_COMMANDS section (remove comment markers) and build the source in VS Code to enable Host Action Commands, so the printer can fully communicate with Octoprint. [2023-02-08 20_38_21-● Configuration_adv.h -…

This runout sensor integrates w/Octoprint running on Pi: Runout Filament Sensor for OctoPrint on Raspberry Pi: Amazon.com: Industrial... Runout Filament Sensor for OctoPrint on Raspberry Pi: Amazon.com: Industrial & Scientific

Octoprint Info

General Chatting

Danabw February 12, 2023, 5:34am 3

Info here on backpowering when using a Pi to run Octoprint. Backpowering can cause erratic behavior.

Topic		Replies	Views
Octoprint causing sv06 to lose its mind occasionally Sovol SV06 Fully Open Source 3D Printer firmware	8	1763	March 7, 2023
Octoprint and SV06 Plus Issues Sovol SV06 Plus firmware , advice	4	1433	May 28, 2023
Enable HOST_ACTION_COMMANDS Firmware	7	901	May 19, 2023
Sv06 - please enable "host action commands" in firmware General Chatting	2	406	November 29, 2022
Printer disconnected of Octoprint Sovol SV06 Plus octoprint	1	191	August 21, 2024

Octoprint Info

Related topics