First - what happened to the SV06 section? To the question - has anyone with an SV06 added a runout sensor? If so, which one and what dod it take to get things working? Thanks, Tim

I was planning on it, I even had a sensor ready to go, but the only socket on the main board that could accept the connector is occupied already. I contacted sovol to ask them what the cable does and never got a response. The interesting thing is that the cable in that socket has a tag on in labeled…

Hello I think this video can help you even if it’s for an Ender. The motherboard is the same as that of the sovol (32 bits)

[afbeelding] Not my printer but i’am gonna try this.

That’s awfully close to the extruder. Almost no warning. I’d recommend up at the main horizontal header.

Did you figure out how to install the filament sensor in the SV06?

[image] Compatible filament runout sensor for SV06 Sovol SV06 Fully Open Source 3D Printer Hello I have connected it as I describe in the pdf but I bought a sensor for ender 3 and I had to modify it. Check that the Ground pin of the sensor is the normally open NO of the s…

Has anyone added a Filament Runout Sensor to their SV06

Sovol SV06 Fully Open Source 3D Printer

jmfsanjurjo April 16, 2023, 5:36pm 7

Topic		Replies	Views
Compatible filament runout sensor for SV06 Sovol SV06 Fully Open Source 3D Printer	7	4898	October 21, 2026
SV06 Filament Sensor not Recognized Sovol SV06 Fully Open Source 3D Printer	3	79	April 21, 2026
Installed SV06 Filament Sensor & Filament Bracket Roller but filament runout does not pause/stop print Sovol SV06 Fully Open Source 3D Printer	12	806	October 17, 2023
Mainboard DET Cable Sovol SV06 Fully Open Source 3D Printer	1	1805	February 4, 2023
SV06, Sovol Filament Runout sensor, Octprint Sovol SV06 Fully Open Source 3D Printer	2	101	December 29, 2025

Has anyone added a Filament Runout Sensor to their SV06

Related topics