Hello, I have a new SVO06 and have not bee very satisfied with the consistency of it at all. I am now dealing with failed prints and the print head printing off in the middle of nowhere, no matter what I set the Z-offset to. If I tune the z-offset mid print it end up being any where from -12 to -20 …

Extreme Z-offset and bed leveling no longer running

bassamanator January 15, 2023, 5:29am 8

I feel your pain, my friend. I suspect your gantry is no longer aligned with your bed.

Please watch this 2 minutes video for the full bed-leveling procedure. My Tech Fun uses the same sequence as well here.

Topic		Replies	Views
Can't get the probe z offset to work on sv06 Sovol SV06 Fully Open Source 3D Printer	13	1473	January 11, 2023
Printer Problems Sovol SV06 Fully Open Source 3D Printer	3	172	September 25, 2023
SV03 bed levelling issues, Z offset, x axis misaligned Sovol SV03 BIG DD 3D printer	2	1273	June 3, 2023
Brand new sv06 not working! (first layer leveling problems) Sovol SV06 Fully Open Source 3D Printer Challenging , homing	14	1192	July 20, 2023
On my second SV07+ won't level, won't z-level Klipperized SV07 Challenging , advice , leveling	17	512	December 26, 2023