Hi Sovol, is this normal for a new SV05 printer? [image] Btw, klipper runs nicely on the printer :wink: Best regards, Markus

I guess so, mine also have that shape but the other way around with the “valley” in the center.

Same here, I have a valley in the center as well

Hallo Markus wie hast du ihn mit Klipper Geschaft das es läuft , bekomme es einfach nicht hin . Könntest du mir die printer.cfg zukommen lassen ? Lieben Gruß Andreas

# only needed when using mainsail [include mainsail.cfg] [include timelapse.cfg] # This file contains pin mappings for the stock Sovol SV05 # with the 32-bit Creality 4.2.2 board (and GD32F303RET6 mcu). To use this config, during # "make menuconfig" select the STM32F103 with a "28KiB bootloader" and…

Dankeschön Markus Funktioniert super .

Moved Klipper questions to SV05/Klipper topic here: [image] Klipper on SV05 Sovol SV05 Cubic DD @Markus Hi, Markus, thanks for sharing your printer.cfg flie. slight_smile Looks like Andreas ( @Andi85kuehn ) says it works very well. https://forum.sovol3d.com/t/sv05-print-…

SV05 print bed has a 0.237 mm tolerance

Sovol SV05 Cubic DD

Danabw February 17, 2023, 4:19pm 7

Moved Klipper questions to SV05/Klipper topic here:

Topic		Replies	Views
Klipper on SV05 Sovol SV05 Cubic DD	10	6465	August 30, 2023
My printer will NOT calibrate the nozzle low enough-KLIPPER Sovol SV06 Fully Open Source 3D Printer advice	17	366	September 6, 2025
Can't get (used) SV08 to print Sovol SV08	13	328	April 23, 2026
WIP: Sovol SV08 - Optimized G-Code / Macro.cfg / printer.cfg and highspeed settings PETG Sovol SV08 firmware , klipper	3	3747	July 16, 2025
Print failures and crazy noise / sounds with new SV06 Plus Sovol SV06 Plus	31	2352	July 11, 2023

SV05 print bed has a 0.237 mm tolerance

Related topics