Hello, I will preface this by admitting I am a novice. I have just successfully printed the case for an advent calendar, but the little drawers are failing. The first error happened because of a cantilever, and the print didn’t connect where the finger pull is (no instructions on whether to use su…

Oriented with the “back” on the bed leaves you with an almost impossible bridge for the “Front” Put the “bottom” against the build plate with the open “top” facing up. No bridges in that orientation.

Thank you for the tip! I tried that after I dried the filament, but it failed even quicker than usual. I don’t even get it. [IMG_1332]

Were you watching as it printed? Did it print on top then push it off? OR Make unhappy buzzing sound then print to the right? I’m guessing the 2nd choice. Tighten your nozzle at print temperature. Use tweezers to pull the “sock” off the heater once it is hot and give the nozzle a firm but gentle…

You would be correct with the 2nd choice. I will give that a try, thank you!

Hello, I followed a youtube tutorial and did as you suggested, then calibrated. The same issue happened again. It completed the second pass of the bottom layer, made a funny sound, and then went rogue. Should I contact Sovol for tech support?

If anyone has any other suggestions, I would greatly appreciate it. I have tried everything I can find online, and nothing works. The print fails each time, but at least now it fails at the same time. After the second layer, it makes a weird noise, and the extruder prints to the right.

What you are looking for: When printing there is some force up against the tip of the nozzle caused by pressure in the pool of liquid plastic. If there is any slack in between the Z motors and the nozzle tip the nozzle can “Float” and print higher than intended. When the nozzle moves over a non-pri…

Hello, If you encounter any difficulties, you can always contact Sovol. Send an email to info@sovol3d.com with your order number and a description of your issues.

Thank you! This also helped the issue. It was user error (me), as suspected.

[image] mich0111: info@sovol3d.com Thank you, i will do that!

Print failing at the beginning, end, or middle

Sovol SV06 Plus ACE

passagefan November 22, 2025, 4:33pm 11

Thank you, i will do that!

1 Like

Topic		Replies	Views
Sovol SVO6 fails printing around the same layer each time Sovol SV06 Fully Open Source 3D Printer	43	4212	April 17, 2024
All prints have uniform defects at the same height, many many failed prints Sovol SV06 Plus	5	413	April 6, 2024
Printing different PLA than the one that came with the machine? SV06 stops after a few layers, no PLA extruded Sovol SV06 Fully Open Source 3D Printer	12	675	January 13, 2023
Failure adhering in the same corner Sovol SV04 IDEX	5	286	December 7, 2022
Print failures and crazy noise / sounds with new SV06 Plus Sovol SV06 Plus	31	2157	July 11, 2023

Print failing at the beginning, end, or middle

Related topics