Filament somehow coming above heat block and nozzle

[zdoty]

I am somewhat new to 3D printing and have a Sovol SV06.

I am able to print, but something weird is happening and not sure why.

It seems like filament is somehow getting on top of the heat block and also below where nozzle screws in to heat block.

I have tightened everything that I know of, but issue still exist. Again, I can print though. So basically on extremely long prints, I pause, and clean the excess filament that is above the heat block and around where nozzle screws in. Then resume and it finishes.

Any help would be greatly appreciated.

[mich0111]

Hello,
It sounds like a leak in the heatbreak.
It could be boring if you insist.
You should check if the heatbreak is tight and, if so, change it.

[Lion]

Can you post a few pictures showing where the filament is leaking…??