Oozy END_PRINT & runout bugs

[rpcyan]

Also evidently impacts the SV08

Oozy END_PRINT bugfix (& filament runout/resume bugs)

I found a bug in the end_print macro. It is present in ALL of Zero’s firmwares. EDIT: Bugs also in SV06 ACE, SV08, and SV08 Max Sovol intends to retract 4mm (with a little z hop in the middle) in this code block, which would reduce ooze at the end of the print and crud to deal with at the start of the next: {% if printer['filament_switch_sensor filament_sensor'].enable == True and printer['filament_switch_sensor filament_sensor'].filament_detected == True %} {% if (printer.extruder.t…

[Alien_Soldier]

Thanks for the information. However, I didn’t find such a problem on my sv08 printer. In all macros, the values are set to “enable”. I purchased the printer on May 10 of this year. The firmware version is listed as 2.5.0 (2025.11.14).

I was wrong; I’m encountering the same problem mentioned earlier…

[mich0111]

Shouldn’t it be set to “enabled”?

[Alien_Soldier]

At that moment, I got confused.