Hello, My extruder lands at the very back of the bed after the bed and Z calibration (printer settings). This is new and since I reset to factory settings. Any ideas or help would be greatly appreciated! I’ve marked the photo whereabouts the edge of the bed is (in red) [Untitled design(5)]

If you reset factory, don’t forget to recalibrate the entire printer.

Extruder position after bed and Z calibration

passagefan November 22, 2025, 4:21pm 3

Hello, yes, this issue happens after I calibrate.

Topic		Replies	Views
Z-Axis off the End of the Bed Sovol SV06 Plus ACE bed-leveling	4	95	October 2, 2025
Calibration fails after reflash extruder replacement Comgrow T500	2	81	October 24, 2024
Bed leveling and printing not centered Sovol SV06 Fully Open Source 3D Printer	2	1206	August 11, 2023
Extruder dragged across mat Sovol SV06 Plus ACE	0	45	November 22, 2025
Bed not level only in one area Sovol SV06 Plus ACE advice , leveling	7	60	February 13, 2026