Sovol SV01Pro Sovol SV01 PRO
Topic | Replies | Views | Activity | |
---|---|---|---|---|
If direct drive is moved while in pause, it will not return to the same point it was before pausing
|
![]() |
0 | 65 | April 19, 2024 |
Need advice about Jumper Wire on 4.2.2 board for laser engraving module
|
![]() |
0 | 104 | March 24, 2024 |
Filiment not flowing during printing but only during feeding
|
![]() |
0 | 116 | March 5, 2024 |
Laser head on SV01 pro
|
![]() |
0 | 157 | November 18, 2023 |
Sovol Sv01 Pro Pause at height It does not work properly
|
![]() ![]() |
1 | 386 | August 18, 2023 |
Need to re-level after every print
|
![]() ![]() |
2 | 354 | April 13, 2023 |
Filament runout sensor support in Octoprint
|
![]() ![]() ![]() |
3 | 443 | December 30, 2022 |