I installed Eddy via Mainline klipper. It is not the paradise as many sell.
I cannot say it is better. If your room temperature is constant. The effort doesn’t worth it.
I have an OCD and I manually adjust the z offset on the first three lines of purge.
The Eddy with USB has some issues, of your distribution has a bad shielded cable you will have connections issues and wlguess what, the printer stops. Eddysl connection issues are a common thing and some people fixed with a new cable, different cable routing, ferrite rings and good luck.
https://github.com/bigtreetech/Eddy/issues/30
I removed Eddy and went with factory probe. Left the cable there. I opened a ticket with Biqu team. They expect a video of all my setup to decide what to do. So far it doesn’t worth the effort.
Heat you bed for a while so that the temperature sensors are kind of stable before you start your print