So I wired some 24 volt LEDs up to the 1224 pin on the main control board. It is always live. And I was wondering if I could control them in a macro from the main sale interface like I do on the SVO 8 I basically did the same thing with a nozzle LED. I’ve looked through macros and printer config and…

Read threw the. Forum already for the ace. Thank-you tho

Someone just made a Reddit post that seems relevant to this. Hope that helps! I haven’t tried hooking anything up to them myself yet, but pins PB0 and PB1 are hiding on an open mainboard header under the display cable, and are evidently controllable by Klipper. (There’s also PC4 and PC5 test pads t…

Main board pinoits and printer config

Sovol SV06 ACE

Oliver February 7, 2025, 3:56pm 2

Maybe this will help?

Topic		Replies	Views
SV06 ACE Additional LEDs, Fans Sovol SV06 ACE	1	342	April 7, 2025
Change printhead board on sv06 ace Sovol SV06 ACE firmware , advice , klipper	8	225	July 8, 2025
Is there a way to switch the camera's LED via the web interface (Mainsail)? Sovol SV06 ACE	46	2282	May 14, 2026
Toolhead PCB Change Sovol SV06 ACE	4	304	March 29, 2025
Klipper pinouts? Sovol SV06 Plus	3	196	April 13, 2025

Main board pinoits and printer config

Related topics