# Z-Axis off the End of the Bed **URL:** \ **Category:** Sovol SV06 Plus ACE\ **Tags:** bed-leveling\ **Created:** [October 1, 2025, 3:44pm UTC](https://forum.sovol3d.com/t/z-axis-off-the-end-of-the-bed/8813 "2025-10-01T15:44:59Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![Lion](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/lion/32/5586_2.png) [@Lion](https://forum.sovol3d.com/u/Lion)\ **Post date:** [October 1, 2025, 8:44pm UTC](https://forum.sovol3d.com/t/z-axis-off-the-end-of-the-bed/8813/2 "2025-10-01T20:44:25Z")
I’m not sure if the Plus had the same issue as the ACE, but check for a black piece of foam under the bed. > [@Y axis thud/ bottoming out on brand new sv06 ace](https://forum.sovol3d.com/t/y-axis-thud-bottoming-out-on-brand-new-sv06-ace/6322): > > Just got a new svo6 ace but I’m having trouble with the y axis. It seems to be travelling too far foreward and hitting the end of its travel. When it does this it makes a thud and a clicking sound. I have tried all the calibration settings and updated the firmware from v15 to v19 but still no luck. While doing a test print (benchy) it gets halfway through then skips alignment about 4mm then skips back a little bit further on. Im guessing it’s all related. How does it sense the end of its run? … Also, there was no reason to do a factory reset when you moved it to another table, all you had to do was run the calibrations again. --- _[View the full topic](https://forum.sovol3d.com/t/z-axis-off-the-end-of-the-bed/8813)._