# The print is stuck on the bed **URL:** \ **Category:** Sovol SV02\ **Created:** [September 28, 2022, 11:57pm UTC](https://forum.sovol3d.com/t/the-print-is-stuck-on-the-bed/618 "2022-09-28T23:57:38Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![cnguyen](https://avatars.discourse-cdn.com/v4/letter/c/58956e/32.png) [@cnguyen](https://forum.sovol3d.com/u/cnguyen)\ **Post date:** [September 28, 2022, 11:57pm UTC](https://forum.sovol3d.com/t/the-print-is-stuck-on-the-bed/618/1 "2022-09-28T23:57:39Z")
Hello; My print is stuck on the bed and can not be removed. Any advices to remove the print. Thank you. chinh Nguyen ---
**Author:** ![Sofans](https://avatars.discourse-cdn.com/v4/letter/s/a88e4f/32.png) [@Sofans](https://forum.sovol3d.com/u/Sofans)\ **Post date:** [September 29, 2022, 9:32am UTC](https://forum.sovol3d.com/t/the-print-is-stuck-on-the-bed/618/2 "2022-09-29T09:32:18Z")
Can I have a pic of that? ---
**Author:** ![Tidalvirus](https://avatars.discourse-cdn.com/v4/letter/t/f475e1/32.png) [@Tidalvirus](https://forum.sovol3d.com/u/Tidalvirus)\ **Post date:** [September 29, 2022, 9:42pm UTC](https://forum.sovol3d.com/t/the-print-is-stuck-on-the-bed/618/3 "2022-09-29T21:42:08Z")
What filament? PLA? If so, and you’re on the glass bed, and you can out it in the freezer, do that for maybe 10-30 minutes. The print should pop right off. ---
**Author:** ![suzygs1000](https://avatars.discourse-cdn.com/v4/letter/s/278dde/32.png) [@suzygs1000](https://forum.sovol3d.com/u/suzygs1000)\ **Post date:** [October 13, 2022, 4:28am UTC](https://forum.sovol3d.com/t/the-print-is-stuck-on-the-bed/618/4 "2022-10-13T04:28:51Z")
This bed looks the same as that on my CR-6 SE, but the prints pretty well fall off that when it cools. I had the same problem as you with my first print, the butterfly. I had one hell of a job removing the model, and was worried about damaging the bed. At least we won’t have a problem with not sticking to the bed…