# SV07 stops mid print **URL:** https://forum.sovol3d.com/t/sv07-stops-mid-print/8644 **Category:** Sovol Klipperized SV07 **Created:** [September 3, 2025, 7:29pm UTC](https://forum.sovol3d.com/t/sv07-stops-mid-print/8644 "2025-09-03T19:29:15Z") **Posts on this page:** 1 **Showing post:** 3
### Author: ![SheepInACart](https://avatars.discourse-cdn.com/v4/letter/s/2acd7d/32.png) [@SheepInACart](https://forum.sovol3d.com/u/SheepInACart) #### Post date: [January 7, 2026, 6:59am UTC](https://forum.sovol3d.com/t/sv07-stops-mid-print/8644/3 "2026-01-07T06:59:19Z")
Old thread, but it was most likely the MksPi CPU in the Klipad overheating and triggering a shutdown rather than something software. You can add monitoring to the software or a cooling fan (I did both here: [The Sv07 is still an amazing deal... but here is how you fix a brand new one](https://forum.sovol3d.com/t/the-sv07-is-still-an-amazing-deal-but-here-is-how-you-fix-a-brand-new-one/9349)), but for a simple “hands off” test if that was your issue, just take the screen off the bracket by sliding it upwards to expose its vent and aim a powerful fan at it, try a long print. If you no longer crash, you have your answer. A lot less drastic than taking anything apart or flashing firmware, where a stuff up will turn your printer into a paperweight, and even if you don’t make it worse you’ve cratered your chances of claiming warranty for a defect. --- _[View the full topic](https://forum.sovol3d.com/t/sv07-stops-mid-print/8644)._