# SV07 Double Sided PEI Plate

**URL:** <https://forum.sovol3d.com/t/sv07-double-sided-pei-plate/3406>\
**Category:** Sovol Klipperized SV07\
**Created:** [September 3, 2023, 6:33am UTC](https://forum.sovol3d.com/t/sv07-double-sided-pei-plate/3406 "2023-09-03T06:33:19Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Timpraetor](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/timpraetor/32/268_2.png) [@Timpraetor](https://forum.sovol3d.com/u/Timpraetor)\
**Post date:** [September 3, 2023, 6:33am UTC](https://forum.sovol3d.com/t/sv07-double-sided-pei-plate/3406/1 "2023-09-03T06:33:19Z")

</div>

Hi Folks,

An important tip regarding the double sided PEI plate provided with the SV07 Plus - be sure to wash both sides with hand soap and warm water. This makes a massive difference in the way prints adhere to the surface.

Also, if you’re working during the day around the printer (so you can keep an eye on it), I recommend (through experience) that you allow the bed to heat soak to 90C for at least two 30 minute periods (non-printing). Also, my bed is around 8C off versus the thermistor reported temperature, so I set my bed around 5C warmer than the suggested temperature for the filament I’m using.

IIIDMax PLA+ is printing great in this printer. I got a really good looking 24 minute benchy at 200C nozzle and 65C bed.

Tim

---

<div class="post-metadata">

**Author:** ![nazghul](https://avatars.discourse-cdn.com/v4/letter/n/8797f3/32.png) [@nazghul](https://forum.sovol3d.com/u/nazghul)\
**Post date:** [October 6, 2023, 1:04pm UTC](https://forum.sovol3d.com/t/sv07-double-sided-pei-plate/3406/2 "2023-10-06T13:04:11Z")

</div>

About the somewhat random bed temperature: As my workroom’s temperature is down to 18 °C (the wife refuses to heat much more as it’s in the barn area :)) I had temperature differences of up to 10 °C.

So I’ve bought these bad boys: [https://www.amazon.de/dp/B08CXZK8TY](https://www.amazon.de/dp/B08CXZK8TY), unmounted the bed, glued one of the isolator sheets below it, mount, calibrate, … now, when I set the bed temperature to 65 degreen it’s between 65 (in the center) and 62 (at the borders).

Have to change all my temperature presets for filaments in Cura 😉