# SV06 Wire attached to bed disconnected?

**URL:** <https://forum.sovol3d.com/t/sv06-wire-attached-to-bed-disconnected/1410>\
**Category:** Sovol SV06 Fully Open Source 3D Printer\
**Created:** [January 24, 2023, 4:36am UTC](https://forum.sovol3d.com/t/sv06-wire-attached-to-bed-disconnected/1410 "2023-01-24T04:36:01Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![FrossTFox](https://avatars.discourse-cdn.com/v4/letter/f/bcef8e/32.png) [@FrossTFox](https://forum.sovol3d.com/u/FrossTFox)\
**Post date:** [January 24, 2023, 4:36am UTC](https://forum.sovol3d.com/t/sv06-wire-attached-to-bed-disconnected/1410/1 "2023-01-24T04:36:01Z")

</div>

![20230121_212521520](https://canada1.discourse-cdn.com/flex030/uploads/sovolforum/original/1X/7018a9b629b42e449f8173bf21e3e126311e3f3a.jpeg)

I finished leveling my bed, and an error popped up for Bed Temp, and to reset. I checked under the bed and this wire was disconnected. What can I do?

---

<div class="post-metadata">

**Author:** ![Bjoern](https://avatars.discourse-cdn.com/v4/letter/b/46a35a/32.png) [@Bjoern](https://forum.sovol3d.com/u/Bjoern)\
**Post date:** [January 24, 2023, 6:16pm UTC](https://forum.sovol3d.com/t/sv06-wire-attached-to-bed-disconnected/1410/2 "2023-01-24T18:16:09Z")

</div>

Honestly? The fast way is to strip a bit of the insulation & solder it or ask someone who is capable of doing that for you.  
The other way: Make a warranty claim, send your printer abroad & wait until it comes back…

---

<div class="post-metadata">

**Author:** ![sovol3delger](https://avatars.discourse-cdn.com/v4/letter/s/4bbf92/32.png) [@sovol3delger](https://forum.sovol3d.com/u/sovol3delger)\
**Post date:** [April 12, 2023, 4:51pm UTC](https://forum.sovol3d.com/t/sv06-wire-attached-to-bed-disconnected/1410/3 "2023-04-12T16:51:25Z")

</div>

They will send a new bed out and you can replace it quite easily, no need to send the printer back.

> [@Sv06 failure](https://forum.sovol3d.com/t/sv06-failure/2238/3):
>
> I had a similar problem but mine was the positive lead coming off. As the bed bled the heat from my soldering iron I couldnt get the pad hot enough to solder it back on. Contact support by email and they will send a new bed out. To speed things up take a photo of your serial number on the bottom of your power supply as they will ask for that. Yeh I have been there… The reason mine failed was that the main part of the lead wasnt zip tied and the back and forth motion caused the cable to get br…