# SV06 start and end Gcode

**URL:** <https://forum.sovol3d.com/t/sv06-start-and-end-gcode/901>\
**Category:** General Chatting\
**Created:** [November 28, 2022, 8:20pm UTC](https://forum.sovol3d.com/t/sv06-start-and-end-gcode/901 "2022-11-28T20:20:07Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![AlanK](https://avatars.discourse-cdn.com/v4/letter/a/c89c15/32.png) [@AlanK](https://forum.sovol3d.com/u/AlanK)\
**Post date:** [November 28, 2022, 8:20pm UTC](https://forum.sovol3d.com/t/sv06-start-and-end-gcode/901/1 "2022-11-28T20:20:07Z")

</div>

Ordered a SV06 and was wondering if there is a start and end Gcode that would be added to the slicer? like an auto z and bed level

---

<div class="post-metadata">

**Author:** ![Sofans](https://avatars.discourse-cdn.com/v4/letter/s/a88e4f/32.png) [@Sofans](https://forum.sovol3d.com/u/Sofans)\
**Post date:** [November 29, 2022, 2:48am UTC](https://forum.sovol3d.com/t/sv06-start-and-end-gcode/901/2 "2022-11-29T02:48:53Z")

</div>

I think the gcode for bed leveling is in the firmware. You may need to follow the instruction and remember to store the setting.

---

<div class="post-metadata">

**Author:** ![Jenss](https://avatars.discourse-cdn.com/v4/letter/j/59ef9b/32.png) [@Jenss](https://forum.sovol3d.com/u/Jenss)\
**Post date:** [November 30, 2022, 2:23pm UTC](https://forum.sovol3d.com/t/sv06-start-and-end-gcode/901/3 "2022-11-30T14:23:45Z")

</div>

isn’t there an example on the SD card to print out?  
There you can see which G code is used at the beginning and end.  
In between the G code that makes the movements and prints