# SV06 Not a Decent First Layer

**URL:** <https://forum.sovol3d.com/t/sv06-not-a-decent-first-layer/4612>\
**Category:** Sovol SV06 Fully Open Source 3D Printer\
**Created:** [February 29, 2024, 12:22am UTC](https://forum.sovol3d.com/t/sv06-not-a-decent-first-layer/4612 "2024-02-29T00:22:05Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![swordfish](https://avatars.discourse-cdn.com/v4/letter/s/d26b3c/32.png) [@swordfish](https://forum.sovol3d.com/u/swordfish)\
**Post date:** [February 29, 2024, 12:22am UTC](https://forum.sovol3d.com/t/sv06-not-a-decent-first-layer/4612/1 "2024-02-29T00:22:05Z")

</div>

SV06 received on Feb 17, 2024 and haven’t been able to get a good firsst layer after numerous levelling and Z offset corrections. As of Feb 27 filament got stuck in heater. Managed to clean it out and today it stuck again.  
Very disappointed in this printer.