# \[SV06 Klipper Screen\]Unable to bed level & Filament stops extruding during print **URL:** \ **Category:** Sovol SV06 Fully Open Source 3D Printer\ **Tags:** leveling\ **Created:** [July 27, 2024, 2:48pm UTC](https://forum.sovol3d.com/t/sv06-klipper-screen-unable-to-bed-level-filament-stops-extruding-during-print/5383 "2024-07-27T14:48:22Z")\ **Posts on this page:** 1\ **Page:** 1
**Author:** ![SV06owner](https://avatars.discourse-cdn.com/v4/letter/s/f07891/32.png) [@SV06owner](https://forum.sovol3d.com/u/SV06owner)\ **Post date:** [July 27, 2024, 2:48pm UTC](https://forum.sovol3d.com/t/sv06-klipper-screen-unable-to-bed-level-filament-stops-extruding-during-print/5383/1 "2024-07-27T14:48:22Z")
Hi all First time poster here. As per the title, my SV06 has suddenly developed two (in my opinion) major issues. Issue 1: When I try to use the automatic bed levelling function, it tests the first 5 point on row 1 just fine, but then it goes for a 6th and as the sensor probe is now past the print bed, it doesn’t stop descending and forces the hotend into the print bed, bending it in the process. I have noticed that when i do the usual “Home all” the X/Y coords of the front left corner that it first goes to is x450 and Y470.5, could this hint at the issue? I think the print bed is only 220x220x250. I have factory reset the firmware thinking a bit may have flipped somewhere but this has not helped at all. Issue 2: The printer stops extruding filament at the exact same point on the same print, and does not extrude at all on other prints, i know for a fact the nozzle is not clogged as right before I printed, I would extract, clear, reinsert and extrude the filament to make sure that was not the cause. There are no abnormal sounds when it decides to stop extruding, but i did notice that it stopped pulling on the filament despite the gearwheel on the front still rotating as normal. I have tightened, loosened and checked the temps but nothing seems to work. Does anyone have any idea as to how I could solve these issues?