# SV06 connected to octoprint shows firmware issues **URL:** \ **Category:** Sovol SV06 Fully Open Source 3D Printer\ **Created:** [November 21, 2022, 10:32pm UTC](https://forum.sovol3d.com/t/sv06-connected-to-octoprint-shows-firmware-issues/849 "2022-11-21T22:32:52Z")\ **Posts on this page:** 1\ **Showing post:** 14
**Author:** ![jamby](https://avatars.discourse-cdn.com/v4/letter/j/7ba0ec/32.png) [@jamby](https://forum.sovol3d.com/u/jamby)\ **Post date:** [December 1, 2022, 7:07pm UTC](https://forum.sovol3d.com/t/sv06-connected-to-octoprint-shows-firmware-issues/849/14 "2022-12-01T19:07:10Z")
Jenss / sovol3delger Ok the power has been restored after 25 hrs so I can get on line… Big problem is the ft/sd cards I am using are to BIG. So ordered some 8g cards. Now wait. The card that came with the printer is a story. I printed Benchy and all went well but after loading a couple of other files and printing them it suddenly stopped working. Anytime I tried it showed “SD INIT FAIL” and when checked in linux with fdisk -l it reported no partition table. I hadn’t checked that before but I do remember seeing 3 files listed, manual, benchy, and the bin file. So it got chucked… check out this link and the instructions about how to flash firmware. [SV06 Mainboard brick after updating Sovol Firmware - #5 by Melthor](https://forum.sovol3d.com/t/sv06-mainboard-brick-after-updating-sovol-firmware/862/5) about half way down theres and answer from Sovol with a link to a YouTube Video… Thanks Guys Jim --- _[View the full topic](https://forum.sovol3d.com/t/sv06-connected-to-octoprint-shows-firmware-issues/849)._