# SV06 ABL starts too far back on plate

**URL:** <https://forum.sovol3d.com/t/sv06-abl-starts-too-far-back-on-plate/1468>\
**Category:** Sovol SV06 Fully Open Source 3D Printer\
**Created:** [January 29, 2023, 5:14pm UTC](https://forum.sovol3d.com/t/sv06-abl-starts-too-far-back-on-plate/1468 "2023-01-29T17:14:49Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![AdamByram](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.sovol3d.com/adambyram/32/288_2.png) [@AdamByram](https://forum.sovol3d.com/u/AdamByram)\
**Post date:** [January 29, 2023, 7:18pm UTC](https://forum.sovol3d.com/t/sv06-abl-starts-too-far-back-on-plate/1468/2 "2023-01-29T19:18:37Z")

</div>

Check out this thread - it sounds like the issue I had with mine where the bed cable was getting caught between the bed and the back of the printer. The cable should come straight from the bed over the top of the printer’s base and not dip below the frame until it’s outside of the printer (photo in the other post).

> [@Auto Bed Levelling: SV06](https://forum.sovol3d.com/t/auto-bed-levelling-sv06/888/8):
>
> I got the SV06 today and set it up. The PSU fan is noisy. I installed the firmware SV06-192A-1028-1.3.bin. Autoleveling only checks the first 5 points.

---

_[View the full topic](https://forum.sovol3d.com/t/sv06-abl-starts-too-far-back-on-plate/1468)._