# Stepper motor Part # for X and Y

**URL:** <https://forum.sovol3d.com/t/stepper-motor-part-for-x-and-y/1810>\
**Category:** Sovol SV06 Fully Open Source 3D Printer\
**Created:** [February 26, 2023, 4:29am UTC](https://forum.sovol3d.com/t/stepper-motor-part-for-x-and-y/1810 "2023-02-26T04:29:04Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![novyc](https://avatars.discourse-cdn.com/v4/letter/n/edb3f5/32.png) [@novyc](https://forum.sovol3d.com/u/novyc)\
**Post date:** [February 26, 2023, 4:29am UTC](https://forum.sovol3d.com/t/stepper-motor-part-for-x-and-y/1810/1 "2023-02-26T04:29:04Z")

</div>

Hello,

I noticed that the X Motor(Stepper) gets up to 80 Celsius. Would like to buy a spare in case it stops working.

Does anyone know what the part # is for the Stepper motors on SV06?

Thanks

---

<div class="post-metadata">

**Author:** ![Contraman](https://avatars.discourse-cdn.com/v4/letter/c/bc79bd/32.png) [@Contraman](https://forum.sovol3d.com/u/Contraman)\
**Post date:** [March 17, 2023, 10:12pm UTC](https://forum.sovol3d.com/t/stepper-motor-part-for-x-and-y/1810/2 "2023-03-17T22:12:43Z")

</div>

This forum is not much use is it.  
Sadly, I see so many questions that are unanswered or just ignored

---

<div class="post-metadata">

**Author:** ![Pcken](https://avatars.discourse-cdn.com/v4/letter/p/b19c9b/32.png) [@Pcken](https://forum.sovol3d.com/u/Pcken)\
**Post date:** [September 24, 2023, 10:43am UTC](https://forum.sovol3d.com/t/stepper-motor-part-for-x-and-y/1810/3 "2023-09-24T10:43:21Z")

</div>

I’ve just installed X and Y stepper motors size, 42x48 and they run a lot smoother and cooler.