# Sovol SV04 IDEX - Extruder 2 Not Leveling Properly Across the Bed

**URL:** <https://forum.sovol3d.com/t/sovol-sv04-idex-extruder-2-not-leveling-properly-across-the-bed/7211>\
**Category:** Sovol SV04 IDEX\
**Tags:** bed-leveling\
**Created:** [March 14, 2025, 11:40pm UTC](https://forum.sovol3d.com/t/sovol-sv04-idex-extruder-2-not-leveling-properly-across-the-bed/7211 "2025-03-14T23:40:13Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Bjoern](https://avatars.discourse-cdn.com/v4/letter/b/46a35a/32.png) [@Bjoern](https://forum.sovol3d.com/u/Bjoern)\
**Post date:** [March 15, 2025, 11:22am UTC](https://forum.sovol3d.com/t/sovol-sv04-idex-extruder-2-not-leveling-properly-across-the-bed/7211/2 "2025-03-15T11:22:39Z")

</div>

Hello Pipan & welcome to the forum!  
Your right printhead is likely to tilt if the four grub screws in the back holding part are not tight.  
[This thread contains a solution for your problem](https://forum.sovol3d.com/t/another-post-with-leveling-questions-on-the-sv04/1390).  
Good luck!  
Björn

---

_[View the full topic](https://forum.sovol3d.com/t/sovol-sv04-idex-extruder-2-not-leveling-properly-across-the-bed/7211)._