# Settings for ultimaker cura slicer

**URL:** <https://forum.sovol3d.com/t/settings-for-ultimaker-cura-slicer/2139>\
**Category:** Sovol SV06 Plus\
**Created:** [April 4, 2023, 6:52pm UTC](https://forum.sovol3d.com/t/settings-for-ultimaker-cura-slicer/2139 "2023-04-04T18:52:37Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![jimhurlburt](https://avatars.discourse-cdn.com/v4/letter/j/2bfe46/32.png) [@jimhurlburt](https://forum.sovol3d.com/u/jimhurlburt)\
**Post date:** [April 4, 2023, 6:52pm UTC](https://forum.sovol3d.com/t/settings-for-ultimaker-cura-slicer/2139/1 "2023-04-04T18:52:37Z")

</div>

I use linux almost excusivly. Uliimaker cura seems like the best slicer that will run under linux.

Where can I find the settings for the svo6 plus for ultimaker?

Thanks,  
Jim

---

<div class="post-metadata">

**Author:** ![ashok](https://avatars.discourse-cdn.com/v4/letter/a/ed655f/32.png) [@ashok](https://forum.sovol3d.com/u/ashok)\
**Post date:** [April 9, 2023, 6:56am UTC](https://forum.sovol3d.com/t/settings-for-ultimaker-cura-slicer/2139/2 "2023-04-09T06:56:10Z")

</div>

[Sovol SV06 Plus | Cura Settings & Profile - Guide & List (the3dprinterbee.com)](https://the3dprinterbee.com/sovol-sv06-plus-cura-settings/#Layer_Height) These worked pretty well for me