# Sensorless Homing--\> Sensored Homing
**URL:** https://forum.sovol3d.com/t/sensorless-homing-sensored-homing/1197
**Category:** Sovol SV06 Fully Open Source 3D Printer
**Tags:** solved
**Created:** [January 2, 2023, 11:30pm UTC](https://forum.sovol3d.com/t/sensorless-homing-sensored-homing/1197 "2023-01-02T23:30:22Z")
**Posts on this page:** 5
**Page:** 1
### Author:  [@marksampson](https://forum.sovol3d.com/u/marksampson)
#### Post date: [January 2, 2023, 11:30pm UTC](https://forum.sovol3d.com/t/sensorless-homing-sensored-homing/1197/1 "2023-01-02T23:30:22Z")
My SV06 works well but the loud noise from sensorless homing means I can’t print at night in my small apartment due to the homing noise.
I have homing switches I can wire/mount but was wondering where I should connect the wires on the controller board and if there is a parameter I can change in Cura or my printers software to use sensored homing instead on sensorless.
Thanks,
Mark
---
### Author:  [@sv06](https://forum.sovol3d.com/u/sv06)
#### Post date: [January 7, 2023, 1:20pm UTC](https://forum.sovol3d.com/t/sensorless-homing-sensored-homing/1197/2 "2023-01-07T13:20:55Z")
The only loud thing is the Z-align, right?
You don’t have to do this before every print.
If it happens on X and Y you can adjust the Sensorless Homing value in the Advanced Settings.
---
### Author:  [@marksampson](https://forum.sovol3d.com/u/marksampson)
#### Post date: [January 8, 2023, 6:33pm UTC](https://forum.sovol3d.com/t/sensorless-homing-sensored-homing/1197/3 "2023-01-08T18:33:30Z")
It is a loud X axis homing but I didn’t realize this is not required for every print. I just won’t home the X at the beginning of every print.
If I did get want to look at the sensorless homing value in the advanced settings, how do I get there? I looked through the settings and didn’t see a place where I can change the value (when the dropdown is set to show all settings). I also didn’t see anything when I “home” "sensor, “homing”, etc. Thanks!
---
### Author:  [@sv06](https://forum.sovol3d.com/u/sv06)
#### Post date: [January 8, 2023, 8:39pm UTC](https://forum.sovol3d.com/t/sensorless-homing-sensored-homing/1197/4 "2023-01-08T20:39:19Z")
Sorry, I thought the values can be changed.
Maybe they are hardcoded in firmware…
---
### Author:  [@marksampson](https://forum.sovol3d.com/u/marksampson)
#### Post date: [January 9, 2023, 5:36pm UTC](https://forum.sovol3d.com/t/sensorless-homing-sensored-homing/1197/5 "2023-01-09T17:36:36Z")
You were right, you can change the homing values in the advanced settings in the printer. I had been looking in Cura 🙂 So that’s why I didn’t find it. This seems to have solved my issues.